Before use, give the Cure Accelerator a good shake for about 30 seconds to ensure the thickening agent is well-blended and returns to a liquid state. To make cleanup easier, consider wearing disposable rubber gloves. Below, you'll find instructions for using it with Seam Grip WP and Aquaseal adhesives.

Precleaner

1. Begin by spot testing an inconspicuous area for colorfastness.
2. Apply a small amount of Cure Accelerator to the damaged area using a brush.
3. Thoroughly buff the area with a rag until it's dry or allow it to air dry.
4. For fabric surfaces, proceed to apply the adhesive as you normally would. For smooth surfaces, use sandpaper to roughen them first, and then repeat steps 2 and 3.
5. If a white film appears after Cure Accelerator dries, simply remove it with soap, water, and a sponge.

Cure Accelerator

1. Mix 1 part Cure Accelerator with 3-4 parts Seam Grip WP, Aquaseal FD, or Aquaseal SR using a stick, toothpick, or knife. Make sure to thoroughly blend them on a non-absorbent surface like plastic.
2. Immediately apply the mixture to the damaged area.
3. Keep the repaired area level and allow it to cure for at least 2 hours before use. It's a good idea to test it before putting it to regular use.

Storing Aquaseal FD Cure Accelerator

Remember to cap the Cure Accelerator tightly and store it in a cool, dry place.